Why does a SAN access data from the server faster than a hard drive? |
| > |
QUESTION:
Why does a SAN access data from the server faster then a local hard drive?
|
|
|
To continue reading for free, register below or login
To read more you must become a member of SearchStorage.com
ANSWERED September 2004:
Several things determine the speed for data access from a server, including:
- Speed of the storage interface (1 Gb, 2 Gb Fibre Channel versus 20-40 MB SCSI)
- Speed of server adapters (PCI and PCI-X bus speed)
- The server's I/O rate and ability (processor speed, memory)
- Congestion or storage interface activity (other activity)
- Speed and configuration of the storage system (cache, RAID, disks, etc).
- The type of data and data access pattern (large, small, random, sequential)
- Type and speed of disk drives being used (RPM, latency, throughput)
Assuming an apples-to-apples comparison, it is possible for a local hard disk to perform similar to a SAN-attached hard disk -- that is if they have the same performance characteristics, similar speed storage interfaces and configuration. However, typically it's not an apples-to-apples comparison. Generally, you're comparing the speed of a local-attached hard disk drive to the performance of a SAN-attached RAID array. This is not a fair comparison because the RAID array may have cache; more disk drives are configured using RAID, which could help performance. Also, the local hard disk drive may be attached to a slower interface than the SAN. For perspective, people also compare the wire speed of the direct-attached host storage to that of a SAN interface. It is important to understand what is being compared and try not to get fooled into believing wire speed performance numbers, especially on individual disk drives.
Read Randy Kerns' answer to this question.
|
|
|
|
|
|
|
|
Search and Browse the Expert Answer Center
Search and browse more than 25,000 question and
answer pairs from more than 250 TechTarget industry experts.
|
|
|
|
|
|
|
|
|
|
|
|
